EMS Foot Stimulator with Infrared Support & Foldable Design

Start gently. Sit comfortably, place your bare feet fully on the pads, and begin at the lowest intensity. Increase slowly until you feel a mild pulsing or light muscle engagement—never sharp pain. For your first few sessions, keep intensity low and focus on getting comfortable with the sensation. If anything feels unpleasant, lower intensity or stop and restart later.

WY-320 is designed for repeatable at-home wellness sessions. Many users build a regular routine during the week and adjust based on comfort and tolerance. If you’re new, start with fewer sessions and increase gradually. If you notice lingering soreness or discomfort, take a break for a day and resume at a lower intensity. Consistent, comfortable use tends to work better than pushing intensity.

You may feel tingling, rhythmic pulsing, or gentle muscle activation in the feet and lower legs. Some users describe it as a “working” sensation that becomes relaxing once they find the right level. Sensations vary by mode and intensity, and it’s normal for the feeling to change as your body adapts. You should not feel sharp pain, burning, or strong numbness—if you do, lower intensity or stop.

This is normal. Sensation can change as your muscles warm up, your posture shifts, or foot contact changes on the pads. If it suddenly feels too strong, reduce intensity. If it feels weaker, reposition your feet for full contact and adjust intensity gradually. The best setting is the one that stays comfortable for the full session.

Yes. You can adjust intensity at any time during a session to stay within a comfortable range. Many users start low, then increase gradually once they feel settled. If the sensation becomes too strong at any point, simply dial it back. The best intensity is one you can maintain comfortably for the full session.

Do not use WY-320 if you have a pacemaker, implanted defibrillator, or other implanted electronic medical device. Avoid use if you are pregnant or have epilepsy. Do not use on broken, irritated, or inflamed skin, or if you have severe loss of sensation in your feet. If you have a medical condition, recent surgery, or are under medical care, consult a qualified clinician before use. WY-320 is a wellness device and is not intended to diagnose, treat, cure, or prevent any disease.

Often, yes—start gently. Begin at the lowest intensity, keep sessions comfortable, and increase gradually over time. Make sure your feet are clean and dry, sit with relaxed posture, and stop if the sensation becomes uncomfortable. If you have significant sensitivity or reduced sensation, check with a clinician before using any stimulation device.

First, confirm both bare feet are fully placed on the pads and you’re seated comfortably. Increase intensity gradually until you feel a mild pulsing or engagement. Small posture changes can affect sensation—keep your feet flat and avoid crossing your legs. If needed, try a different mode and re-check that your feet maintain steady contact with the pads.

Yes. WY-320 is designed for seated use at a desk, on a sofa, or while reading. It’s motor-free, so there’s no mechanical “motor noise” during use. Place both feet flat on the pads, keep your legs relaxed, and adjust intensity for comfort. For best consistency, avoid crossing your legs and keep steady contact throughout the session.

Traditional foot massagers usually rely on motors, rollers, kneading heads, vibration, or compression to create a mechanical massage sensation. WY-320 is different: it uses controlled electrical stimulation for structured, repeatable sessions—plus soothing infrared light support. Because it’s motor-free, it’s also quiet during use, making it easy to fit into a daily routine without the “machine sound” typical of motor-driven massagers.

Yes. WY-320 is designed to be easy to move and store: it’s foldable, lightweight, and compact when put away, yet built to feel sturdy and secure during use. Many users keep it near a desk or sofa, then fold and store it neatly after sessions.

After use, power off the device and wipe the foot pads with a soft, slightly damp cloth. Do not soak the device or use harsh chemicals. Let it fully dry before storing. For storage, fold the unit (if applicable), keep it in a cool, dry place away from heat and direct sunlight, and use your storage case if included to protect the device and keep accessories organized.

If the session doesn’t feel right, stop and try again at a lower intensity with careful foot placement. If you’re still not satisfied, please refer to our return policy for eligibility and steps. You can also contact our support team—we can help with setup, comfort tips, and troubleshooting so you get the best experience.